Set of aluminium volleyball posts


Set of two aluminium volleyball posts designed and manufactured to comply with the European Norm EN-1271 and the F.I.V.B. regulations.

They are made of a ribbed circular section tube with a 120 mm diameter. There is a double groove on one side of the post. This groove, that is facing the play court, contains the elements or plates to which the net is attached and tighten too.

The posts are equipped with a ruler to position the height of the net. Only one of the two posts that take part in the set-up, contain a simple cable tightening system, while the other is used to attach the net.

Both the element that attaches the net and the tightening system can be moved vertically along the groove to adjust the height of the net as needed for various sports, fixing it at a certain height with polypropylene knobs that are found on the posts. On one of the fixing elements the attachment hook is fixed while the other, the tightening one, can be moved along this plate due to a screw with an independent handle delivered with the posts, tightening the net this way.

The posts are fixed to the floor by embedding a square steel section that protrudes from the bottom with a length of 400 mm., with two separate anchors PV002 (not included) made of the same aluminium as the posts. The anchors should be placed correctly in the floor as a lot of stress is exercised upon them.

All screws and steel elements have been submitted to a zinc treatment.

The product is painted with polyester powder paint, which is applied after a degreasing treatment using a pressurised phosphate bath and cured in an oven at 200 ºC.

Note: These posts are not meant for high level competition, only for training or school level.